Practice online with 28 Cisco 350-401 Dumps exam questions to help you develop your skills and contribute to candidates for the Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) exam.
Not only that, but I also shared a 100% successful plan to pass the 350-401 ENCOR exam:
Candidates only need to practice the 853 Cisco 350-401 Dumps exam questions provided by leads4pass (download link: https://www.leads4pass.com/350-401.html),
The practice material has been verified by the IT team, covering the complete 350-401 ENCOR practical exam questions, and also comes with PDF and VCE learning methods to choose from, to ensure that you can easily pass the 350-401 ENCOR exam.
Next, candidates can practice the 28 Cisco 350-401 Dumps exam questions online, with answers posted at the end of the article:
Cisco 350-401 Dumps Exam Questions
QUESTION 1:
Refer to the exhibit. An engineer must create a configuration that prevents R3from receiving the LSA about
172.16.1.4/32. Which configuration set achieves this goal? [Missing the exhibit]
A. On R3 ip access-list standard R4_L0 deny host 172.16.1.4 permit any
router ospf 200
distribute-list R4_L0 in
B. On R3 ip prefix-list INTO-AREA1 seq 5 deny 172.16.1.4/32 ip prefix-list INTO-AREA1 seq 10 permit 0.0.0.0/0 le 32
router ospf 200
area 1 filter-list prefix INTO-AREA 1 in
C. On R1 ip prefix-list INTO-AREA1 seq 5 deny 172.16.1.4/32 ip prefix-list INTO-AREA 1 seq 10 permit 0.0.0.0/0 le 32
router ospf 200
area 1 filter-list prefix IN TO-AREA1 in
D. On R1 ip prefix-list INTO-AREA1 seq 5 deny 172.16.1.4/32 ip prefix-list INTO-AREA1 seq 10 permit 0.0.0.0/0 le 32
router ospf 200
area 1 filter-list prefix INTO-AREA1 out
QUESTION 2:
Which AP mode allows an engineer to scan configured channels for rogue access points?
A. sniffer
B. monitor
C. bridge
D. local
QUESTION 3:
Refer to the exhibit.
The EtherChannel between SW2 and SW3 is not operational which action resolves this issue?
A. Configure the channel-group mode on SW2 Gi0/0 and Gi0/1 to on.
B. Configure the channel-group mode on SW3 Gi0/0 and Gi0/1 to active.
C. Configure the mode on SW2 Gi0/0 to the trunk.
D. Configure the mode on SW2 Gi0/1 to access.
QUESTION 4:
Refer to the exhibit.
A network engineer is configuring OSPF between router R1 and router R2. The engineer must ensure that a DR/BDR election does not occur on the Gigabit Ethernet interfaces in area 0. Which configuration set accomplishes this goal?
A. R1(config-if)interface Gi0/0 R1(config-if)ip ospf network point-to-point R2(config-if)interface Gi0/0
R2(config-if)ip ospf network point-to-point
B. R1(config-if)interface Gi0/0 R1(config-if)ip ospf network broadcast
R2(config-if)interface Gi0/0
R2(config-if)ip ospf network broadcast
C. R1(config-if)interface Gi0/0 R1(config-if)ip ospf database-filter all out
R2(config-if)interface Gi0/0
R2(config-if)ip ospf database-filter all out
D. R1(config-if)interface Gi0/0 R1(config-if)ip ospf priority 1
R2(config-if)interface Gi0/0
R2(config-if)ip ospf priority 1
QUESTION 5:
How does EIGRP differ from OSPF?
A. EIGRP is more prone to routing loops than OSPF
B. EIGRP has a full map of the topology, and OSPF only knows directly connected neighbors
C. EIGRP supports equal or unequal path cost, and OSPF supports only equal path cost.
D. EIGRP uses more CPU and memory than OSPF
QUESTION 6:
DRAG DROP
Drag and drop the snippets onto the blanks within the code to construct a script that configures BGP according to the topology. Not all options are used, and some options may be used twice.
Select and Place:
Correct Answer:
QUESTION 7:
Which tool is used in Cisco DNA Center to build generic configurations that are able to be applied on device with similar network settings?
A. Command Runner
B. Template Editor
C. Application Policies
D. Authentication Template
QUESTION 8:
An engineer must export the contents of the devices object in JSON format. Which statement must be used?
A. json.repr(Devices)
B. json.dumps(Devices)
C. json.prints(Devices)
D. json.loads(Devices)
QUESTION 9:
A network engineer is enabling HTTPS access to the core switch, which requires a certificate to be installed on the switch signed by the corporate certificate authority Which configuration commands are required to issue a certificate signing request from the core switch?
A. Core-Switch(config)#crypto pki enroll Core-Switch Core-Switch(config)#ip http secure-trustpoint Core-Switch
B. Core-Switch(config)#crypto pki trustpoint Core-Switch Core-Switch(ca-trustpoint)#enrollment terminal Core-
Switch(config)#crypto pki enroll Core-Switch
C. Core-Switch(config)#crypto pki trustpoint Core-Switch Core-Switch(ca-trustpoint)#enrollment terminal Core-
Switch(config)#ip http secure-trustpoint Core-Switch
D. Core-Switch(config)#ip http secure-trustpoint Core-Switch Core-Switch(config)#crypto pki enroll Core-Switch
QUESTION 10:
Refer to the exhibit.
Which configuration change will force BR2 to reach 209 165 201 0/27 via BR1?
A. Set the weight attribute to 65.535 on BR1 toward PE1.
B. Set the local preference to 150 on PE1 toward BR1 outbound
C. Set the MED to 1 on PE2 toward BR2 outbound.
D. Set the origin to igp on BR2 toward PE2 inbound.
QUESTION 11:
Refer to the exhibit.
Which command must be applied to Routed to bring the GRE tunnel to an up/up state?
A. Router1(config)#interface tunnel0
B. Router1(config-if)#tunnel source GigabitEthernet0/1
C. Router1(config-if)#tunnel mode gre multipoint
D. Router1(config-if)#tunnel source Loopback0
QUESTION 12:
DRAG DROP
Drag and drop the descriptions from the left onto the routing protocol they describe on the right.
Select and Place:
Correct Answer:
QUESTION 13:
An engineer must create an EEM script to enable OSPF debugging in the event the OSPF neighborship goes down.
Which script must the engineer apply?
A. Option A
B. Option B
C. Option C
D. Option D
Question 14:
How does Cisco Trustsec enable more access controls for dynamic networking environments and data centers?
A. uses flexible NetFlow
B. assigns a VLAN to the endpoint
C. classifies traffic based on the contextual identity of the endpoint rather than its IP address
D. classifies traffic based on advanced application recognition
Question 15:
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. MACsec
B. IPsec
C. SSL
D. Cisco Trustsec
Question 16:
What does Cisco DNA southbound APIs provide?
A. Interface between the controller and the network devices
B. NETCONF API interface for orchestration communication
C. RESful API interface for orchestrator communication
D. Interface between the controller and the consumer
The Southbound API is used to communicate with network devices.
Question 17:
Which NGFW mode block flows crossing the firewall?
A. Passive
B. Tap
C. Inline tap
D. Inline
Question 18:
Which two pieces of information are necessary to compute SNR? (Choose two.)
A. EIRP
B. noise floor
C. antenna gain
D. RSSI
E. transmit power
Question 19:
Which requirement for an Ansible-managed node is true?
A. It must be a Linux server or a Cisco device.
B. It must have an SSH server running.
C. It must support ad hoc commands.
D. It must have an Ansible Tower installed.
Question 20:
What is the difference between the enable password and the enable secret password when password encryption is enabled on an IOS device?
A. The enable password is encrypted with a stronger encryption method.
B. There is no difference and both passwords are encrypted identically.
C. The enable password cannot be decrypted.
D. The enabled secret password is protected via stronger cryptography mechanisms.
Question 21:
Refer to the exhibit.
Which configuration establishes EBGP neighborship between these two directly connected neighbors and exchanges the loopback network of the two routers through BGP?
A. Option A
B. Option B
C. Option C
D. Option D
Question 22:
In which part of the HTTP message is the content type specified?
A. HTTP method
B. URI
C. header
D. body
Question 23:
Which behavior can be expected when the HSRP versions are changed from 1 to 2?
A. Each HSRP group reinitializes because the virtual MAC address has changed.
B. No changes occur because versions 1 and 2 use the same virtual MAC OUI.
C. Each HSRP group reinitializes because the multicast address has changed.
D. No changes occur because the standby router is upgraded before the active router.
Question 24:
A response code of 404 is received while using the REST API on Cisco UNA Center to POST to this URI.
/dna/intent/api/v1 /template-programmer/project
What does the code mean?
A. The client made a request for a resource that does not exist.
B. The server has not implemented the functionality that is needed to fulfill the request.
C. The request was accepted for processing, but the processing was not completed.
D. The POST/PUT request was fulfilled and a new resource was created, Information about the resource is in the response body.
Question 25:
What is the structure of a JSON web token?
A. three parts separated by dots header payload, and signature
B. header and payload
C. three parts separated by dots version header and signature
D. payload and signature
Question 26:
Which OSPF network types are compatible and allow communication through the two peering devices?
A. broadcast to nonbroadcast
B. point-to-multipoint to nonbroadcast
C. broadcast to point-to-point
D. point-to-multipoint to broadcast
Question 27:
At which Layer does Cisco DNA Center support REST controls?
A. EEM applets or scripts
B. Session layer
C. YMAL output from responses to API calls
D. Northbound APIs
Question 28:
Which statement about agent-based versus agentless configuration management tools is true?
A. Agentless tools require no messaging systems between master and slaves.
B. Agentless tools use proxy nodes to interface with slave nodes.
C. Agent-based tools do not require a high-level language interpreter such as Python or Ruby on slave nodes.
D. Agent-based tools do not require the installation of additional software packages on the slave nodes.
Publish the answer:
| Numbers: | Q1 | Q2 | Q3 | Q4 | Q5 | Q6 | Q7 | Q8 | Q9 | Q10 | Q11 | Q12 | Q13 | Q14 |
| Answers: | D | B | C | A | C | IMAGE | B | B | B | C | D | IMAGE | C | C |
| Q15 | Q16 | Q17 | Q18 | Q19 | Q20 | Q21 | Q22 | Q23 | Q24 | Q25 | Q26 | Q27 | Q28 |
| A | A | D | BD | B | D | A | C | A | A | A | A | D | A |
The 28 Cisco 350-401 dumps exam questions are collected by me and shared with all candidates for free. This free plan can really help you improve your strength, continue to pay attention, and share more effective materials.
If you are preparing for the 350-401 ENCOR exam, I highly recommend you to use the 350-401 dumps: https://www.leads4pass.com/350-401.html, it really helps you to be 100% successful.
